| Transducer Type |
Condenser |
| Polar Pattern |
NONE: Cartridge NOT Included with this Model, Must Use One of the Following:
Supercardioid, Cardioid |
| Frequency Response |
50 Hz - 17 kHz |
| Output Impedance |
EIA Rated at 150 Ohms (170 Ohms actual) |
| Output Configuration |
Active balanced |
| Sensitivity (1 kHz) |
Cardioid -35 dBV/Pa; Supercardioid -34 dBV/Pa / Cardioid 18 mV/Pa; Supercardioid 21 mV/Pa |
| Equivalent Output Noise (A-weighted) |
Cardioid: 28 dB(A)
Supercardioid: 27 dB(A) |
| Maximum SPL |
Cardioid: 121 dB
Supercardioid: 120 dB |
| Signal-to-Noise Ratio |
(referenced at 94 dB SPL at 1 kHz)
Cardioid: 66 dB
Supercardioid: 68 dB |
| Dynamic Range (1 kilohm load at 1 kHz) |
3 dB |
| Common Mode Rejection (10 Hz to 100 kHz) |
45 dB minimum |
| Preamplifier Output Clipping Level |
-8 dBV (0.4 V) (1% THD) |
| Polarity |
3-Pin XLR: Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector
5-Pin XLR: Positive sound pressure on diaphragm produces positive voltage on pin 4 relative to pin 2 of output XLR connector |
| Logic Connections |
LED IN: Active low (=1.0V), TTL compatible. Absolute maximum voltage: -0.7V to 50V
LOGIC OUT: Active low (=1.0V), syncs up to 20mA, TTL compatible
Absolute maximum voltage: -0.7V to 50V (up to 50V through 3 kilohms) |
| Mute Switch Attenuation |
-50 dB minimum |
| Operating Temperature |
-18 to 57 deg. C (0 to 135 deg. F) |
| Storage Temperature |
-29 to 74 deg. C (-20 to 165 deg. F) |
| Relative Humidity |
0 to 95% |
| Power Requirements |
48 to 52 Vdc phantom, 8.0 mA |
| Weight |
0.154 lbs (0.07kg) |
