SHURE MX418SE/N 18" Gooseneck with Flange Mount and 10 foot Side Exit Cable (No Microphone Cartridge)
The MX418SE/N is an 18" gooseneck mic with no cartridge and and in-line preamp, shock mount, flange mount, 10-ft side-exit (or bottom-exit) cable and snap-fit foam windscreen.
Features:
- Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum
- Interchangeable cartridges provide the right polar pattern for every application
- Balanced, transformerless output for increased immunity to noise over long cable runs
- Shock mount provides over 20 dB isolation from surface vibration noise
- Locking flange mount for permanently securing microphone to lecterns, pulpits, or conference tables
- Snap-fit foam windscreen
- Programmable on/off switch and LED on/off indicator (MX412D/MX418D)
- New brighter LED improves visibility under strong ambient lighting (MX412D/MX418D)
- Logic input and output terminals for remote control or use with automatic microphone mixers (MX412D/MX418D)
- Supplied shock mount for more than 20 dB isolation from surface transmitted noise (MX412SE/MX418SE)
- Supplied threaded flange mount for permanently securing the microphone toa lectern, pulpit, or conference table (MX412SE/MX418SE)
Specs.
| Transducer |
Condenser |
| Polar Pattern |
NONE: Cartridge NOT Included with this Model, Must Use One of the Following:
Cardioid (C). Recommended for general sound reinforcement applications. Pickup angle (-3 dB) = 130°.
Supercardioid (S). Recommended for sound reinforcement applications requiring narrow or more distant coverage. Pickup angle (-3 dB) = 115°.
Omnidirectional (O). Recommended for recording or remote monitoring applications. Pickup angle = 360°. |
| Frequency Response |
50 Hz to 17 kHz |
| Dynamic Range (Typical) |
96.2 dB, (@ 1 kW Load) |
| Signal-to-Noise Ratio |
Cardioid: 66.0 dB
Supercardioid: 67.5 dB
Omnidirectional: 73.5 dB, (All Referenced @ 94 dB SPL) |
| Maximum Input Sound Level |
Cardioid: 124.2 dB
Supercardioid: 122.7 dB
Omnidirectional: 116.7 dB (All: 1 kHz @ 1% THD, 1 kW Load) |
| Power Requirements |
Phantom, (11 to 52v, DC) |
| Output Impedance |
150 Ohms (180 Ohms Actual @ 1 kHz) |
| Output Connectors |
XLR3-M Type |
| Pad |
None |
| Low Frequency Roll-Off |
None |
| Applications |
Speeches, Lectures, Houses of Worship, Mount on Podiums, Lecturnes, etc. |
| Dimensions |
Microphone: 19.721 x .77" (500.91 x 19.56mm) LxDiameter
Mounting Flange: 1.75" (45.5mm) In Diameter |
| Weight |
1.82 lbs. (82 kg) |
|
