| Rated power bridge mode 4 Ohms: |
900 Watts @ 1 kHz at <0.1% T.H.D. |
| Rated power (2 X 2 Ohms): |
450 Watts per channel @ 1 kHz at <0.1%
T.H.D.both channels driven |
| Rated power (2 X4 Ohms): |
300 Watts per channel @ 1 kHz at <0.05%
T.H.D. both channels driven |
| Rated power (2 X 8 Ohms): |
200 Watts per channel @ 1 kHz at <0.025%
T.H.D.both channels driven |
| Rated power (1 X 2 Ohms): |
490 Watts @ 1 kHz at <0.1% T.H.D. |
| Power bandwidth: |
10 Hz - 30kHz; +0, -3 dB at rated 150 Watts 8 Ohm power |
| T.H.D.(2 X 2 Ohms): |
<0.1%@360 Watts per channel from 20 HZ to 20 kHz |
| T.H.D.(2 X 4 Ohms): |
<0.1%@240 Watts per channel from 20 HZ to 20 kHz |
| T.H.D.(2 X 8 Ohms): |
<0.1%@160 Watts per channel from 20 HZ to 20 kHz |
| Minimum load impedance: |
>-65 dB @ 1 kHz |
| Maximum RMS voltage swing: |
330 Watts @ 1 kHz at <0.05% T.H.D. |
| Frequency response: |
220 Watts @ 1 kHz at <0.025% T.H.D. |
| Input CMRR: |
2 Ohms |
| Rated power (1 X 4 Ohms): |
42 Volts |
| Rated power (1 X 8 Ohms): |
10 Hz - 100 kHz; +0, -3 dB at 1 Watt |
| Phase response: |
+5 to -15 from 20 Hz to 20 kHz |
| Input impedance: |
10 k Ohms, balanced |
| Cooling: |
Two temperature dependant variable speed 80mm high output DC fans |
| Controls: |
Two front panel attenuators, rear panel mode switch and gain select switch |
| Voltage gain: |
0.775V, 32 dB or 26 dB |
| Crosstalk: |
>-60 dB @ 1 kHz at rated power @ 8 Ohms |
| Hum and noise: |
>-105 dB, "A" weighted referenced to rated power @ 8 Ohms |
| Slew rate: |
>30V/us |
| Damping factor (8 Ohms): |
>400:1 @ 20Hz - 1 kHz |
| Indicator LEDs: |
2 Clip,2 signal presence, 1 active status,2 Protection |
| Protection: |
Thermal, DC, turn-on bursts, subsonic, incorrect loads |
| Connectors: |
XLR, Speakon and Binding Post speaker output, 240/230 Volt 20 amp IEC mains |
| Construction: |
16 ga. Steel |
| Dimensions: |
89 mm x 483 mm x 496 mm |
| Net weight: |
16kg |
| Gross weight: |
19 kg |
